View Issue Details

IDProjectCategoryView StatusLast Update
0004458PathBugpublic2020-10-12 17:57
Reportersliptonic Assigned To 
PrioritynormalSeverityminorReproducibilityalways
Status newResolutionopen 
Product Version0.19 
Target Version0.19 
Summary0004458: [PATH] Engrave 'start at vertex' gives wrong path
DescriptionThe engraving operation allows for changing the vertex to start at. Some values produce correct paths. Others
produce paths that gouge the part.
Steps To ReproduceCreate a cube.
Create a job and add an engrave operation
Select the four edges on the top face and add them to the base tab of the engrave
The path should generate correctly.
change the 'start at vertex' property to '3' and recompute

The starting position is recalculcated but the path now gouges the part and misses one edge.
TagsNo tags attached.
FreeCAD Information<!--ATTENTION:
COMPLETELY ERASE THIS AFTER PASTING YOUR
Help > About FreeCAD > Copy to clipboard
NOTE: just the snippet alone will do without anything else included.
The ticket will not be submitted without it.
-->

Activities

There are no notes attached to this issue.

Issue History

Date Modified Username Field Change
2020-10-12 17:23 sliptonic New Issue
2020-10-12 17:52 sliptonic Summary Engrave 'start at vertex' gives wrong path => [PATH] Engrave 'start at vertex' gives wrong path
2020-10-12 17:57 sliptonic Project FreeCAD => Path