View Issue Details

IDProjectCategoryView StatusLast Update
0004128TechDrawFeaturepublic2021-02-06 06:38
Reporterwandererfan Assigned To 
PrioritynormalSeverityminorReproducibilityhave not tried
Status newResolutionopen 
Target Version0.20 
Summary0004128: Allow Angled Section Views
DescriptionForum discussion

Currently, the Section tool will only create sections in 4 directions (left, right, up, down). There are occasions where a Section at an angle (say 45*, left/down to right/up) to the Base view would be useful.
Additional InformationThere was a question about this in the German forum some time ago. German forum thread re angled Section
TagsNo tags attached.
FreeCAD Information


There are no notes attached to this issue.

Issue History

Date Modified Username Field Change
2019-09-13 11:49 wandererfan New Issue
2019-09-13 12:09 wandererfan Additional Information Updated
2021-02-06 06:38 abdullah Target Version => 0.20