View Revisions: Issue #2188

Summary 0002188: Modifying a pocket sketch destroys orientation and position of another pocket
Revision 2017-01-15 13:59 by Kunda1
Steps To Reproduce 1. Open the attached file
2. Select drills-1-sketch and look where this sketch is placed and which holes it creates
2. Open nut1-cutout-sketch and change the holes-distance (e.g. 15mm to 12), close the sketch.

Observed:
drills-1-sketch is suddenly in a weird angle and the generated holes are some grove on the back of the part.

Expected:
drills-1-sketch should be in the same place as before.
Revision 2015-07-09 09:59 by fra.orolo
Steps To Reproduce
1. Open the attached file
2. Select drills-1-sketch and look where this sketch is placed and which holes it creates
2. Open nut1-cutout-sketch and change the holes-distance (e.g. 15mm to 12), close the sketch.

Observed:
drills-1-sketch is suddenly in a weird angle and the generated holes are some grove on the back of the part.

Expected:
drills-1-sketch should be in the same place as before.