View Revisions: Issue #4335

Summary 0004335: Section line wrong position when original view is rotated
Revision 2020-05-05 15:36 by matsievskiysv
Steps To Reproduce
  • Create new project
  • Start Part module
  • Insert cylinder with Radius 10 and Height 100
  • Select Front View
  • Select TechDraw module and create new Page
  • Insert View in Page
  • Insert View Section: Looking up with default settings
  • Select View and set Rotation to 90
  • Select Section A - A and change Section Plane Origin z coordinate form 50 to 30
  • Observe Section line moving it the wrong direction
Revision 2020-05-05 15:36 by matsievskiysv
Steps To Reproduce
  • Create new project
  • Start Part module
  • Insert cylinder with Radius 10 and Height 100
  • Select Front View
  • Select TechDraw module and create new Page
  • Insert View in Page ()
  • Insert View Section: Looking up with default settings ()
  • Select View and set Rotation to 90 ()
  • Select Section A - A and change Section Plane Origin z coordinate form 50 to 30
  • Observe Section line moving it the wrong direction ()
Revision 2020-05-05 15:34 by matsievskiysv
Steps To Reproduce
  • Create new project
  • Start Part module
  • Insert cylinder with Radius 10 and Height 100
  • Select Front View
  • Select TechDraw module and create new Page
  • Insert View in Page ()
  • Insert View Section: Looking up with default settings ()
  • Select View and set Rotation to 90 ()
  • Select Section A - A and change Section Plane Origin z coordinate form 50 to 30
  • Observe Section line moving it the wrong direction ()