View Revisions: Issue #4261

Summary 0004261: Bad behavior when using '°' unit in expressions
Revision 2020-02-04 14:21 by openBrain
Steps To Reproduce   - Create a new document, select PartDesign WB
  - Add a sketch (you can just let it empty)
  - Create a DatumPlane (locate it at any position)
  - Try to enter as expression for DatumPlane/AttachmentOffset/Angle the following :'90°-atan(Sk' => You'll notice first that 'Sketch' is only proposed when you enter the 'k', then that if you select 'Sketch' proposal with down arrow, it is replaced by 'SSketch' in the expression (doubled 'S')

If you use 'deg' instead of '°' in the expression, the 2 issues described aren't present : 'Sketch' is proposed as soon as 'S' is entered, and it is correctly entered in the expressions if you select the proposal with down arrow.
Revision 2020-02-04 14:20 by openBrain
Steps To Reproduce
  1. Create a new document, select PartDesign WB
  2. Add a sketch (you can just let it empty)
  3. Create a DatumPlane (locate it at any position)
  4. Try to enter as expression for DatumPlane/AttachmentOffset/Angle the following :'90°-atan(Sk' => You'll notice first that 'Sketch' is only proposed when you enter the 'k', then that if you select 'Sketch' proposal with down arrow, it is replaced by 'SSketch' in the expression (doubled 'S')
If you use 'deg' instead of '°' in the expression, the 2 issues described aren't present : 'Sketch' is proposed as soon as 'S' is entered, and it is correctly entered in the expressions if you select the proposal with down arrow.