View Revisions: Issue #4253

Summary 0004253: No "snap to intersection" implemented in Sketcher
Revision 2020-01-21 16:23 by openBrain
Additional Information You can use workarounds like defining a point by "snap to line" to two different lines.
But if you close the contour this way, sketcher starts to claim nonsense about redundant dependencies. :-)

(Using self compiled pyside2 packages to make FreeCAD run with KDE NEON.)
Revision 2020-01-21 10:33 by Bernhard Schiffner
Additional Information You can use workarounds like defining a point by "snap to line" to two different lines.
But if you close the contour this way, sketcher starts to claim nonsense about redundant dependencies. :-)

(Using self compiled pyside2 packages to make FreeCAD run with KDE NEON.)